Vinyls special

Vinyl colors and special designs for car and bike

Currently the technique of labeling of cars has become a very usual. Within the main advantages of vinyl car we can say that thanks to that it is stickers of large dimensions, we can cover the smaller parts of our vehicle until vinilar the car completely, besides that is considered to be a very cheaper than paint. In this section we can find vinyl colors and special designs to decorate.

How long does a vinyl, special design for car?

Following your installation properly and keeping it properly, the approximate duration of a vinyl car is about five years (taking into account that a vinyl interior that is not exposed to damage shall be retained more optimally).

Can I install this myself a vinyl on my car?

The answer is yes. It is a very simple procedure.

What I need to know before putting a vinyl on my car?

-We will have to clean the area very well, to vinilar, as a dirty area can cause complications at the time of paste adhesive.

-We will have to measure the area to vinilar to know exactly the length of the vinyl that we will need.

Do I have to buy the exact measure of the piece that I want to vinilar?

We recommend that you always buy one meter, if at the time of vinilar we find any complication.

What do I need to install a vinyl?

-The vinyl elected with as we wish.

-A spatula to smooth the surface and remove any air bubbles.

-Heat gun (or a device everyday heat such as a dryer).

-A razor knife to remove the excess vinyl and cut to suit our taste.

How to install a vinyl?

-After the mediate area to vinilar, we will have to cut the piece of vinyl with a size a little bigger than you measure the piece.

-We will remove the protective band of adhesive and place the vinyl on the chosen surface.

-We will start to stick, our vinyl one end to the other.

-We carefully observe our vinyl does not have imperfections. In the case of being, for example, a wrinkle or bubble just make press carefully with a spatula the area with damage.

-Once we make sure that our vinyl has been as we expected, we will put heat to adhere properly.

-We can use a cutter to remove the leftovers of our vinyl and give a finish to the taste.

-After removing all the excess material, we can go over the edges with a spatula.