Kit test hidroimpresión by which you'll be able to perform a test in your house as it makes the hidroimpresión.
Product customization
Don't forget to save your customization to be able to add to cart
Kit Test Hidroimpresión for Car and Bike
Kit test hidroimpresión to try on any piece and see the operation of the hidroimpresión. Watch the video to see all the steps to perform hidroimpresión.
The kit consists of:
-An activator spray 400 ml
-Two sheets to choose from
-Detailed Manual
Steps to use our kit hidroimpresión test
The hidroimpresión may be made by any person, it is not necessary to have any technical knowledge.
- Clean the piece to decorate with hidroimpresión and paint it the desired color (the base has to be white or grey for a perfect finish)
- Fill a bucket of water to 25-30°C.
- Put some masking tape on the foil.
- Put the sheet of hidroimpresión in the water. If there is any bubble to slide it to the ends with the tip of your finger. Wait 90 seconds.
- Sprinkle the foil with the spray activator and wait 10 seconds.
- Introducing the piece to decorate slowly and the water.
- Leave the piece in water to remove impurities.
- Leave to dry the piece and then apply the lacquer.
NOTE: if we wrong our kit hidroimpresión test no problem. We will use the sandpaper that comes in the kit to sand the piece and start again. It's that easy.
Specialists in kit hidroimpresión test, any doubt, please consult us
Customer Questions and Answers
Product ratings
Kit Test Hidroimpresión