Kit Hidroimpresión advanced (recommended)

Kit Hidroimpresión advanced for amateurs. Includes everything needed for the initiation into the world of the hidroimpresión. Ideal to make some trim out of the car, mirrors, rims or spoilers.

More details

72,99 € 72.99

FREE SHIPPING (More info.)

WrapWorkers Hydro

Do you have any doubt about this product? Ask us!

Kit Hidroimpresión advanced

Kit hidroimpresión advanced is the kit more complete ideal to start in the world of the hidroimpresión. Includes everything needed for the initiation into the world of the hidroimpresión.

You do not need any technical knowledge to use our kit hidroimpresión advanced

The Kit hidroimpresión advanced includes:

  • Detailed Manual
  • Base color to choose (white, black, wood, gray)
  • 2 Lacquer to choose from (matte or gloss)
  • 4 sheets of hidroimpresión to choose (you can choose four sheets of 0,5x1m)
  • Activator
  • Tape masking
  • Gloves
  • Mask
  • Sandpaper

NOTE: The only thing that is not included in the kit is a bucket/pail to submerge the piece. We recommend to purchase in any store or bazaar that is transparent. The price of these cubes is usually around 8-12€.

If you've never done hidroimpresión and do not know which to choose, we advise you to choose white primer, lacquer gloss, 1 sheet hidroimpresión fiber 3D carbon, 1 sheet hidroimpresión camouflage artic, 1 sheet hidroimpresión carbon gold and 1 sheet hidroimpresión sticker bomb. It is the most sold and easy to make. When ordering, indicate the products you want.

Steps to use our kit hidroimpresión advanced

The hidroimpresión may be made by any person, it is not necessary to have any technical knowledge.

  1. Clean the piece to decorate with hidroimpresión and paint it the desired color (the base has to be white or grey for a perfect finish)
  2. Fill a bucket of water to 25-30°C.
  3. Put some masking tape on the foil.
  4. Put the sheet of hidroimpresión in the water. If there is any bubble to slide it to the ends with the tip of your finger. Wait 90 seconds.
  5. Sprinkle the foil with the spray activator and wait 10 seconds.
  6. Introducing the piece to decorate slowly and the water.
  7. Leave the piece in water to remove impurities.
  8. Leave to dry the piece and then apply the lacquer.

NOTE: if we wrong our kit hidroimpresión advanced no problem. We will use the sandpaper that comes in the kit to sand the piece and start again. It's that easy.

Specialists in kit hidroimpresión advanced any doubt ask us

After saving your customized product, remember to add it to your cart.



* required fields

Send us your question

Be the first to ask a question about this product!

Question about the product

* Required fields

The question has been correctly sent

The question has been correctly sent

Related products

Recommended Products

Best Products